Setting the print server to the Zyxel Keenetic (Giga / Lite) NMDS with firmware v2

P1ratRuleZZZ

12 years ago

Faced with the problem of, when the printer, configured on here this manual, works fine with the firmware v1, stopped working with firmware v2 Beta. It turned out, that in the new firmware, the printer must work through CIFS (Windows Network / Samba shares) — то есть роутер должен расшарить принтер в сети Windows, and then through the usual network environment it can be installed. Tried, but it did not. CIFS works very crooked, printer sees, there is no, well, or at all hangs, in general, was not able to adjust. Quite desperate, decided to go into the configuration via telnet, and saw a printer command. In the end, I just switched it in direct mode, and set the port 9100.
About, how to do it, read more.

This is done so:

Open any telnet client (telnet in Windows 7 is disabled by default). Let's take Putty
Logins to the printer, specifying its IP address (it is possible to look at the command ipconfig / all in the box or gateway address Default gateway), I have it 192.168.1.1 (usually the standard). B connection type put telnet. Click Login.
Putty will ask you to log in. Enter the admin password on the router (default 1234). Next we get a control terminal router.
Here you can press the TAB and see a list of available commands. We introduce the printer and press the tab, see attached printers. Yes I Am, there must, the printer must be turned on and connected to the router. I gave this:
```
Usage template:
          printer {id}


   Choose:
        04a9-173a
```
Well, the left dial command:
printer 04a9-173a type directprinter 04a9-173a port 9100
The port can be any, but I have a printer connected to 9100 (by default in Windows so)

A simpler solution, setting of admin

http://zyxel.ru/kb/3548 (Thank you Michael)

A simpler solution, setting of admin

Share: